EOS LIGHTWRIGHT IMPORT HOW TO

Depending on the show file size, it may take a full minute or two for the first sync to be complete. Click the box at top for Use Console Link and I would suggest clicking the box for Get All Cues Now if you have any in the board. If you are on a PC, and are using both Lightwright and EOS on the same computer, you will need to enter 127.0.0.1 instead of the console IP. In the dialogue box that opens, input the IP Address of your console (found by pressing About in EOS and reading the info on the left under IP). Now click the Light bulb shaped icon in the upper right hand corner. In Lightwright, go to Setup>Dimming&Control and under Console type, select the only choice: ETC EOS Family. I have the ports numbered (80) for use with TouchOSC, but they are not relevant to Lighwright. In EOS, go to Setup>System Settings>Show Control. Start up Lightwright if it’s not already and make sure both are in the same show file. It will save you hours of misery in the future.Ĭlick Accept and exit the Shell. This little “1.0 vs 1.1” thing is worth remembering for ANYTHING else with OSC integrating with EOS. Breaking with tradition- you want to choose the older protocol version 1.0 NOT 1.1. Immediately below that, notice that there is a pulldown menu for OSC to choose between two versions of the protocol.

In the network tab, scroll down to Interface Protocols and make sure that UDP Strings & OSC is turned on.

EOS LIGHTWRIGHT IMPORT HOW TO

First, a recap on how to link EOS and Lightwright.īoot up your console, or open EOS Nomad and go into the shell by clicking Settings. A favorite function of mine that Lightwright 6 added is the ability to reconcile patch with EOS through OSC.

Eos lightwright import